Proceed as follows:
❒ turn the knurled ring (A) to ON and press the accelerator pedal to the required
speed;
❒ turn the knurled ring (B) to (+) for at least three seconds, then release it.
The car speed is memorised and it is therefore possible to release the accelerator
pedal.
In the case of need (when overtaking for instance) acceleration is possible simply pressing the accelerator pedal; later, releasing the accelerator pedal, the car will return to the speed memorised previously.
See also:
General failure indication
The warning light on the dial comes on when a failure is detected. ...
Front Fog Lights — If Equipped
The fog light switch is located on the center stack of the instrument panel,
just below the radio.
Fog Light Switch
Press the switch once to turn the front fog lights on. Press the switch a sec ...
Types of bulbs
Several types of bulbs are installed in the vehicle fig. 17:
A Glass bulbs Clipped into position.
To remove them, pull.
B Bayonet connection bulbs Remove from the bulb holder by pressing the bulb ...


