To change the bulb, proceed as follows:
❒ remove the lens (A) as shown by the arrow;
❒ lift protection (B) and remove the bulb (clipped in).
See also:
1. Glow Plug Light — If Equipped
The Glow Plug light will flash during engine oil viscosity sensor measurement
in cold weather.
During this measurement (up to 10 seconds), the starter will be disabled. If
the measured oil visc ...
Trip b ON/OFF (Trip B)
Through this option it is possible to activate (ON) or deactivate (OFF) the Trip
B (partial trip) which show “partial mission” information corresponding to: Trip
Dist. B, Avg. Consump. B, Avg. Spe ...
Inefficient abs system
(amber)
Turning the ignition key to MAR the warning light turns on, but it should go
off after few seconds.
The warning light turns on when the system is inefficient or unavailable. In
this ca ...