Sound system

If the “Sound System” has not been requested, the vehicle features an oddment compartment on the dashboard.

Contact a Fiat Dealership if you want to install a sound system after purchasing

Contact a Fiat Dealership if you want to install a sound system after purchasing your vehicle. Their staff will advise you on how to safeguard the life of the battery. Excessive idle intake can damage the battery and invalid the battery warranty as well.

LIGHT PRESETTING

The system consists of the following:

– sound system power wires;

– wires for front speakers on the dashboard, doors (where provided) and rear speakers for passengers transport versions;

– sound system compartment;

– aerial wire and aerial.

HEAVY PRESETTING

The system consists of the following:

– sound system power wires;

– wires for front speakers on the dashboard;

– 2 speakers on the dashboard;

– wires for door speakers (where provided);

– 2 door speakers;

– 2 rear speakers (for passengers transport versions);

– wires for rear speakers;

– sound system compartment;

– aerial wire and aerial.

Speakers

Speakers

– two mid-range speakers on dashboard, diameter 100 mm, power 30W max each.

– two woofer speakers on front doors, diameter 165 mm, power 40W max each (Panorama versions only).

– two full-range elliptic speakers on rear window shelf, 95 x 154 mm, power 20W max each (Panorama versions only).

Sound system installation

To fit the sound system, remove the oddment compartment shown in fig.

145. To remove the compartment, press it upwards and then pull it out towards the inside of the vehicle.

Cellular phone set-up

    See also:

    Power Convertible Top — If Equipped
    On vehicles equipped with a power convertible top, the power convertible top switch is located on the overhead console. The switch contains two buttons. The passenger side button, which is used to ...

    Sunroof
    It is controlled electrically and it will only work when the ignition key is at MAR. Sunroof is controlled by a switch. When you release it the roof locks in the position it is at that moment. ...

    Front direction indicators
    To change the bulb, proceed as follows: 1) Turn the bulb holder A-fig. 18 and remove it. 2) Remove bulb by pushing it slightly and turning it anticlockwise (bayonet coupling). ...